6 Inch High Pressure Hose Manufacturer
Pubdate: 2023-09-18 09:30 | Hits:
6 Inch High Pressure Hose Manufacturer:（Guide：Introduction→Model→Price→Factory→FAQs）
6 Inch High Pressure Hose Introduction:
The six-inch high-pressure hose is used in chemical and petroleum equipment plants, mint and menthol factories, toothpick factories, freezing plants (including cold storage), apple dry factories, etc., involving asbestos products manufacturing; Animal glue manufacturing; Dyeing and finishing of chemical fiber fabric; Electrical instrument manufacturing; And so many industries. The failure of the strengthening layer is mainly due to the effect of wet or corrosive substances on the layer, which weakens the strength of the hose and leads to rupture at high pressure. Type R15 - Multi-layer wire winding high temperature ultra-high pressure tubing under harsh conditions. Therefore, there is no standard for this kind of hose in the national standards. The old engineers of some enterprises still use the old standards of the past, so some people still choose this model when designing. High pressure steel wire braided hose operating temperature: oil -40℃ ~ 100℃, air -30℃ ~ 50℃, water emulsion +80℃ below. Uses Coal industry Petroleum industry production process fault analysis damage causes Poor manufacturing quality improper use.
6 Inch High Pressure Hose Model:
6 Inch High Pressure Hose Price:
You can consult Hebei Tengshuo company, we will make a reasonable quotation according to your requirements.
6 Inch High Pressure Hose Factory:
Our factory specializes in the production of six inch high pressure hose, shearer high pressure hose, agricultural spray pump high pressure hose, anti-static high pressure hose, serpentine high pressure hose, automotive high pressure hose. Quality assurance, after-sales protection!
6 Inch High Pressure Hose FAQs:
High pressure hose assembly model: KJR31.5-4-32*1.8 Model specific meaning:
31.5- Hose nominal inner diameter hose
4- Number of wire layers,4 layers of winding
32- Maximum working pressure of hose 32MP
1.8-Hose length 1.8m high pressure hose for mining
What effect may the amount of pressure have on the use of high pressure hose?
When the high and low pressure hose is pressed, it will always produce the phenomenon of too tight or too loose, which will cause the quality of the high and low pressure hose to be affected. During assembly, if the amount of pressure is too small, that is, when the pressure between the joint and the high and low pressure hose is too loose, the high and low pressure hose may slip out of the joint in the early stage of use under the action of oil pressure; If the amount of pressure is too large, the joint and the hose are too tight, which can easily lead to local damage to the inner layer of the hose, resulting in cracks, the high-pressure tubing will directly enter the steel wire layer from the rupture, and then squirt out the tail of the jacket along the gap between the steel wire, or have been along the steel wire layer to a place to accumulate, so that the outer layer of rubber bulge.
