Sand Blast High Pressure Hose
Pubdate：2023-10-12 16:31 | Hits：
Sand Blast High Pressure Hose Specification:（Guide：Introduction→Model→Price→Factory→FAQs）
Sand Blast High Pressure Hose Introduction:
Sandblasting high-pressure hose is useful in tire turning factory, rubber products factory, foam plastic factory, carbon dioxide factory, Marine instrument factory, etc., involving metal doors and Windows manufacturing; Aerospace manufacturing; Baked goods manufacturing; Special equipment manufacturing; And so many industries. Automated hydraulic system to transport a certain pressure (higher pressure) and temperature of the petroleum base (such as mineral oil, soluble oil, hydraulic oil, fuel oil, lubricating oil). The rubber layer in the hose is seriously deteriorated, and the obvious reason for the expansion is that the rubber material in the hose is incompatible with the oil of the hydraulic system, and the hose is deteriorated by chemical action. When the hose is installed, it should avoid being in a tension state, even if there is no relative movement at both ends of the hose, it is necessary to keep the hose loose, and the tensioned hose will expand under pressure and reduce the strength. The extruder is again coated with the outer layer of rubber, and then wrapped with lead or cloth vulcanization protective layer. The development of offshore and shallow sea oil fields, therefore, the oil industry in addition to the use of drilling tubing, vibration tubing, but also require the use of shallow sea oil pipelines.
Sand Blast High Pressure Hose Model:
Sand Blast High Pressure Hose Price:
You can consult Hebei Tengshuo company, we will make a reasonable quotation according to your requirements.
Sand Blast High Pressure Hose Factory:
Hebei Tengshuo distribution sandblasting high pressure hose, oil high pressure hose,3/4 steel wire high pressure hose, hydraulic equipment high pressure hose, high pressure wound drilling hose, air conditioning with high pressure hose.
Sand Blast High Pressure Hose FAQs:
How is the bending radius of the hose calculated?
If the type and standard of the hose you are going to use are fixed, the minimum bending radius can be found directly from the corresponding specifications and standards, and the bending can not be less than the specified minimum bending radius when used. When installing high-pressure hose, it is necessary to bend part of the straight section. The straight section should be greater than or equal to three times the outer diameter of the hose, and attention should be paid to the design of the length of the hose.
How to choose high pressure tubing correctly in the use of hydraulic system?
The determination of hydraulic hose in the hydraulic system is determined according to the working pressure of the hydraulic pump!
