Cement High Pressure Hose Assembly
Pubdate: 2023-09-19 10:19 | Hits:
Cement High Pressure Hose Assembly:（Guide：Introduction→Model→Price→Factory→FAQs）
Cement High Pressure Hose Assembly Introduction:
Cement high-pressure hose assembly in the match factory, rubber products factory, welding rod processing plant (welding rod), oil refinery, power supply equipment factory, and other scenarios are useful, involving enamel sanitary ware manufacturing; Sports equipment and accessories manufacturing; Video recording and playback equipment manufacturing; Ceramic products manufacturing; And so many industries. When the hose must be bent, the bending radius should not be too small, and should be greater than 9 times the outer diameter. The joint of the hose and the joint shall have a straight line section greater than 2 times the outside diameter of the pipe. If the amount of pressure is too large, the joint and the hose are too tight, which can easily lead to local damage to the inner layer of the hose, resulting in cracks, and the high-pressure oil will enter the wire layer directly from the rupture, and then squirt out to the tail of the jacket along the gap between the wires. Therefore, in the operation, the lever can not be too sharp, must be gentle. The operating temperature of the oil is too high. Coal industry oil pipes are mainly hydraulic support hose. Subjected to frequent and intense pressure shocks. High-pressure hose bursts are generally not caused by too much static pressure, but are related to the severity and number of pressure shocks.
Cement High Pressure Hose Assembly Model:
Cement High Pressure Hose Assembly Price:
You can consult Hebei Tengshuo company, we will make a reasonable quotation according to your requirements.
Cement High Pressure Hose Assembly Factory:
Our company produces cement high pressure hose assembly, high pressure insulation hose, coal machine high pressure hose, carbon fiber high pressure hose, groove high pressure hose, wire wound high pressure hose, complete models, support custom.
Cement High Pressure Hose Assembly FAQs:
How much is the price of high pressure hose for fully mechanized mining support?
The high pressure hose is mainly composed of an inner rubber layer, two or four or six layers of wire winding layer and an outer rubber layer. High pressure hose mainly works at temperature: -40℃-+100℃, so you must master the temperature, do not use improperly, bring you unnecessary consequences. High-pressure hose cleaning methods and steps 1, according to the location of the use of occasions to determine the erection position of the drill frame. 2. The cleaning machine is composed of motor, reducer box, electrical control box, temperature control system, guide rail and other mechanisms. 3. Run for five minutes without power before drilling.
