Polyurethane High Pressure Hose
Pubdate：2023-09-16 16:59 | Hits：
Polyurethane High Pressure Hose Models（Guide：Introduction→Model→Price→Factory→FAQs）
Polyurethane High Pressure Hose Introduction:
Polyurethane high-pressure hose is useful in enamel factory, concentrator, iron chain factory, chalk factory, copper belt factory, etc., involving the manufacture of special equipment for oil refining and chemical production; Metal pressure vessel manufacturing; Enamel daily necessities and enamel products manufacturing; Vegetable processing; And so many industries. When the hose must be bent, the bending radius should not be too small, and should be greater than 9 times the outer diameter. The joint of the hose and the joint shall have a straight line section greater than 2 times the outside diameter of the pipe. The calender is pressed into a laminated rubber sheet, and the spacer is added to roll and cut into a specified width according to the technical requirements. The rubber layer in the hose is seriously deteriorated, and the obvious reason for the expansion is that the rubber material in the hose is incompatible with the oil of the hydraulic system, and the hose is deteriorated by chemical action. High pressure hose often have these types: fiber reinforced polyurethane hose, fiber reinforced nylon hose, wire reinforced polyurethane hose, wire reinforced nylon hose, wire wound resin hose, food grade hose. Coal industry oil pipes are mainly hydraulic support hose.
Polyurethane High Pressure Hose Model:
Polyurethane High Pressure Hose Price:
You can consult Hebei Tengshuo company, we will make a reasonable quotation according to your requirements.
Polyurethane High Pressure Hose Factory:
Hebei Tengshuo Rubber Products Co., Ltd. produces polyurethane high pressure hose, high pressure hose, silicone high pressure hose, large caliber high pressure hydraulic hose, gas high pressure hose, super high pressure hose, various types of high pressure hose assembly to meet your needs.
Polyurethane High Pressure Hose FAQs:
What kind of high pressure hose is good?
The inner and outer layers of the high pressure hose wall are oil-resistant rubber, and the middle is (2 to 4 layers) cross-braided steel wire or wound steel wire. Poor quality hose will appear: uneven wall thickness of the rubber tube; The wire braid is too tight, too loose or the number of wire layers is too few; The amount of deformation (elongation, shortening or bending deformation) of the hose after pressure is large; Poor outer rubber air tightness leads to corrosion of steel wire; The poor sealing of the inner layer makes the high pressure oil easily enter the wire layer; Adhesive layer and wire layer adhesion is insufficient. The above conditions will reduce the bearing capacity of the hose, and eventually burst at the weak point of the pipe wall.
How to distinguish the quality of high pressure oxygen pipe?
The work is neat, there is a red line in the middle, the rubber should be of good black light quality, and the pressure should be able to reach more than 10 kilograms
