High Pressure Hydraulic Hose
Pubdate：2023-09-15 15:10 | Hits：
High Pressure Hydraulic Hose Specifictions:（Guide：Introduction→Model→Price→Factory→FAQs）
High Pressure Hydraulic Hose Introduction:
High-pressure hydraulic hose is useful in counter factory, paper factory (cloth), leather manufacturing factory, paper products comprehensive processing plant, flour factory, etc., involving printed circuit board manufacturing; Urban rail transit equipment manufacturing; Nuclear power generation; Machine tool accessories manufacturing; And so many industries. If the amount of pressure is too large, the joint and the hose are too tight, which can easily lead to local damage to the inner layer of the hose, resulting in cracks, and the high-pressure oil will enter the wire layer directly from the rupture, and then squirt out to the tail of the jacket along the gap between the wires. During the operation of construction machinery, the sudden rise or decrease of oil pressure in the oil pipe will occur repeatedly, which will constitute frequent pressure impact on the oil pipe, resulting in increased damage to the oil seal of each part, bubbling and cracking of the hose and loose leakage of the pipe joint. The calender is pressed into a laminated rubber sheet, and the spacer is added to roll and cut into a specified width according to the technical requirements. The hose is broken, and the braided steel wire near the break is rusty. The hose is broken, and the outer rubber layer is peeled off for inspection. Do not twist the hose during installation. A slight twist on the hose may reduce its strength and loosen the joint, which should be tightened to the hose rather than the hose to the joint when assembling.
High Pressure Hydraulic Hose Model:
High Pressure Hydraulic Hose Price:
You can consult Hebei Tengshuo company, we will make a reasonable quotation according to your requirements.
High Pressure Hydraulic Hose Factory:
Our factory specializes in high-pressure hydraulic hose, and small-bore high-pressure hose, heat-resistant armouring high-pressure hose, shearer high pressure hose, stainless steel high-pressure hose, high-pressure hose with reliable quality and reasonable price.
High Pressure Hydraulic Hose FAQs:
What is the purpose of hydraulic hose assembly pulse test?
1. The pressure of the hydraulic system is divided into transient pressure and stable pressure, which is concerned about the safe working performance of the high-pressure hose under the transient state, so it is necessary to do pulse test; 2, there are several characteristic words on the mark of the hydraulic pipe to indicate the characteristics of the pipe: Hose hydraulic hose, WP (work pressure) is the working pressure and steady pressure, BP (break pressure) breaking pressure, the latter is more than ten times the former, foreign may reach a hundred times. ; 3, pulse test is because in the working process of constant pressure variable pump, its theoretical curve is without peak damping effect.
High pressure hose Φ30×3×25mpa×3m m30×1.5 What does it mean?
The strength of cement mortar is 30MPa and the strength of concrete is C30. Pa is a unit of pressure, 1Pa is 1N/㎡, 1MPa=1N/mm2. 1Pa is the pressure generated by a force of 1N uniformly pressed on an area of 1 square meters. It can be imagined that 1Pa is a small pressure, and the direct use of Pa as a unit of measurement of pressure will also cause a lot of inconvenience to the actual calculation, so some larger units of measurement are often used. So let's say 1MPa, 1atm, 1mmHg. 1MPa is 1 million times that of 1Pa, that is, 1MPa=10^6Pa.
High pressure hose F731C9C9202012 What does it mean?
This is how the Parker hose assembly is written. Translated into the domestic writing is 19X430X2H/30X2H heavy duty joint this should follow the length.
